Merge remote-tracking branch 'quic/dev/msm-4.14-display' into msm-4.14

* quic/dev/msm-4.14-display:
  msm: clk: qcom: power on PLL when reading PLL registers
  clk: qcom: mdss: add support for dynamic refresh on DSI 14nm PLL
  drm/msm/dp: abort aux and ctrl when simulation is switched off
  msm/sde/rotator: Add rev checks for trinket target
  drm/msm/dp: Add P/N swap support for dp phy
  Revert "drm/msm/sde: fix watchdog vsync timer configuration"
  drm/msm/sde: Add rev checks for trinket target
  drm/msm/sde: Enable ubwc 1.0 for supported targets
  drivers: soc: qcom: enable USB in DisplayPort mode on FSA4480
  drm/msm/dp: add vcpi parameter for set_stream_info
  drm/msm/dp: add debugfs node for max_lclk_khz
  drm/msm/dp: perform mst probe after link training
  drm/msm/dsi-staging: defer dsi probe if backlight device not found
  drm/msm/dp: remove dp_display_post_open operations
  clk: qcom: update 14nm PLL settings as per hardware recommendation
  drm/msm/dsi-staging: add support for dsi dynamic clock switch
  drm/msm/dsi-staging: free roi command packet
  drm/msm/sde: Add global dither memory dump range
  clk: qcom: mdss: add support for 10nm DSI PLL shadow clock
  clk: qcom: check for change in RCG configuration during set_rate
  drm/dp: Add DP_DPCD_REV_XX to drm_dp_helper
  drm: Add DPCD definitions for DP 1.4 FEC feature
  drm/dp: Add definitions for TPS4 bits and macros to check the support
  drm/msm: add split link panel support in sde drm
  drm/msm/dsi-staging: add split link panel support in dsi driver
  ARM: dts: msm: update panel jitter for sw43404 panel
  drm/msm/sde: avoid vbif and wb register dumps in secure mode
  msm/sde/rotator: fix probe defferal issue
  drm/msm/sde: rotator software reset during vbif busy case
  drm/msm/dp: avoid mst_hpd_irq process before mst session start
  drm/msm/sde: fix watchdog vsync timer configuration
  drm/msm/dsi-staging: use display panel's force_clk_lane_hs instead of phy's
  drm/msm/dp: cleanup log messages in mst layer
  ARM: dts: msm: add property to limit the link clock on sm6150
  dt-bindings: drm: msm: add the link clk property information
  drm/msm/dp: implementation to limit the dp link clock frequency
  drm/msm/dp: fix mst mode switch issue
  drm/msm/dp: handle hdcp 2.2 polling in link work
  soc: qmi: dfc: fix dead loop in workqueue dfc_wq
  power: qpnp-qg: Add support for weighted capacity learning
  power: qpnp-fg-gen4: Add support for weighted capacity learning
  power: fg-alg: Loosen capacity learning qualification criterion
  ARM: dts: msm: Add dpdm supply to dwc3-msm on SM6150/sdmmagpie/trinket
  scsi: ufs: obtain VCCQ2 voltage level from DT prior to hard code
  ARM: dts: msm: Add UFS VCCQ2 voltage configuration support for SM6150
  usb: dwc3-msm: Fix maximum_speed determination
  ARM: dts: msm: Add entry for cx ipeak driver for sdmmagpie
  ARM: dts: msm: Disable titan cti for SDMMAGPIE
  ARM: dts: msm: Update QUSB PHY parameters on sdmmagpie
  scsi: ufs: ice: propagate memeory allocation failure error
  cpu/hotplug: Ensure that sched domains are rebuilt before hotplug
  power: qos: Use effective affinity mask
  genirq: Honour IRQ's affinity hint during migration
  usb: dwc3: gadget: Clear req->unaligned/zero flags on cleanup
  soc: qcom: socinfo: Add support for SM8150P HDK soc-id
  Coresight: tmc: need alloc memory before enable tmc etr
  soc: qcom: sysmon-qmi: Fix max qmi msg length
  msm: ipa3: add mhi state check after calling mhi-API
  dwc3-msm: reset hardware on bootup if cable not connected
  dwc3-msm: Fix dwc3_drd_state_string for undefined state
  ARM: msm: dts: Correct npu tcm io space for sdmmagpie
  ARM: dts: msm: add remote debugger support
  defconfig: msm: enable remote debugger driver on sm6150
  ARM: dts: msm: disable MST for Display Port on sdmmagpie
  msm: ipa4: fix to update the channel state logic
  msm: ipa4: fix to change the header address to u64
  arm64: defconfig: Enable qrtr over FIFO driver for sm8150
  qrtr: Add FIFO based communication between VMs
  qrtr: Add support to read qrtr packet size
  eud: avoid suspend and resume callback race with EUD IRQ
  Revert "ARM: dts: msm: Add SPI device nodes for QUPV3 for SA6155"
  msm: ipa: nullify mailbox struct after freeing
  arm64: Enable repeat tlbi warkaround on Kryo4 CPUs
  ARM: dts: msm: Add mindidump id for mss subsystem on sdmmagpie
  mhi: core: provide helper function to check MHI device status
  diag: Increase the number of retries for MDM DCI
  kasan: disable kasan during unwind_frame()
  net: qrtr: Handle IPCR control port format of older targets
  ARM: dts: msm: Enable eud clock voting for sdmmagpie
  ARM: dts: msm: Enable eud clock voting for sm6150
  llcc: Update SCT table entries for sm6150
  soc: qcom: Add support for phy clock voting from eud
  msm: kgsl: Update expected GMU FW version for A618 GPU
  soc: qcom: Create new ramdump device node for SSR minidump
  ARM: dts: msm: Enable cx-ipeak support for sdmmagpie camera
  usb: phy: Add module parameter for eud connected case
  drm/msm/sde: fix race condition in vblank control interrupts
  ARM: dts: msm: Increase WLAN carveout region on sm6150
  ARM: dts: msm: Increase WLAN carveout region on sdmmagpie
  usb: dwc3-msm: Set HOST MODE flag before resume
  qseecom: listener unregister and register optimization
  msm: vidc: Update device clock after cx ipeak logic
  ARM: dts: msm: Update QoS priority for arm9 master for SDMMAGPIE
  ARM: dts: msm: Configure cx ipeak for video for sm6150 and sdmmagpie
  ARM: dts: msm: Enable CX Ipeak support for sdmmagpie
  soc: qcom: Update Cx ipeak driver for multimedia clients
  ARM: dts: msm: Enable LLC for SM6150 GPU
  inet: frags: better deal with smp races
  sdxprairie_defconfig: Add BLSP UART driver in sdxprairie_defconfig
  ARM: dts: msm: Add support for UART dtsi on sdxprairie
  qcom-geni-se: Add IOMMU check in geni common driver
  usb: dwc3-msm: Ensure hardware is reset during role change
  usb: dwc3-msm: add enum for drd_states to remove otg_state usage
  ARM: dts: msm: add synaptics touch support for SDMMAGPIE IDP
  msm: ipa4: Fix to mask the global interrupt INT1
  ion: fix an incorrect pointer dereference
  qcom-geni-se: Add debug logs for bus voting
  ARM: dts: msm: Add SPI device nodes for QUPV3 for SA6155
  spi: spi-geni-qcom: Add spi slave mode support to QUPv3
  sched: remove duplicate initialization
  msm: kgsl: Use correct GBIF settings for A612 GPU
  msm: ipa4: Increase the TAG process timeout
  ARM: dts: msm: Add support for dual display on sdmmagpie
  cnss2: Fix un-initialized RDDM completion
  dma-buf: skip fd iteration for threads created with CLONE_FILES
  msm: kgsl: improve error logging in adreno_irq_handler
  rpmsg: glink: Do not send to remote proc in reset
  ARM: dts: msm: Correct rpm_msg_ram size for trinket
  msm: kgsl: Reset ringbuffer pointers if CP INIT fails
  msm: ipa4: Increase the GSI command poll timeout to 10
  ARM: dts: msm: Update GCC_UFS_PHY_AXI_CLK rate for sdmmagpie and sm6150
  mmc: cmdq_hci: Fix key index refcnt issue with metadata encryption
  msm/sde/rotator: setup irq during first rotator commit

Change-Id: I3dfabc800dfb651c88bd3e726fe725194720fb48
Signed-off-by: Namratha Siddappa <namratha@codeaurora.org>