Merge commit 'AU296' into dev/msm-4.14-display

* commit 'e71e1637':
  Revert "ARM: dts: msm: enable display rsc for sa8155"
  ARM: dts: msm: Add llcc cache dump support for sm6150
  ARM: dts: msm: Add llcc perfmon device for sm6150
  ARM: dts: msm: Add sleep counter node for sm6150
  ARM: dts: msm: Add EUD device node for SM6150
  cnss2: Add support for PCIe WLAN IPA uc SMMU feature
  tty: serial: msm: Add suspend resume support
  power: smb5-lib: Load HW JEITA config in general psy events
  ARM: dts: msm: Add audio support for sm6150 target
  iio: adc5: Add channels and add batt_therm support for SM6150
  msm: ipa: Error prints are misleading fix it
  clk: qcom: gcc: Update frequency table and Fmax for blsp_qup clk
  ARM: dts: msm: Add dpdm regulator and batterydata node to sm6150
  ARM: dts: msm: Add Qgauge device to PM6150
  usb: mon: replace %p with %pK
  net: cnss2: Remove obsolete device ID assigned to QCA6390
  ARM: dts: msm: EMAC changes for qcs405
  wil6210: add support for headroom configuration
  wil6210: support aggregation max window size 64
  wil6210: set edma variables only for Talyn-MB devices
  power: qpnp-qg: Update the recharge/hold-SOC logic
  power: qpnp-qg: Keep GOOD_OCV interrupt enabled at boot
  mhi: core: check MHI PM state under pm_lock
  mhi: core: reduce logging level for errors msg during queue transfer
  mhi: core: release channel locks before removing mhi devices
  msm: mink: fix for infinite loop when listeners are invoked
  Documentation: sound: Add documentation for sm6150 nodes
  ARM: dts: msm: Enable Superspeed on secondary port for QCS405
  usb: phy: Enable VDD on probe for Synopsys SS PHY
  usb: phy: Fix multiple regulator enable calls
  usb: phy: Add the interrupt programming sequence for HS PHY
  ARM: dts: msm: Add audio overlay dt for qrd dvt on SM8150 target
  input: touchscreen: st: enable touch firmware upgrade
  arm64: dma-mapping: Fix cache maintenance issue
  AndroidKernel: Add all generated dlkm to vendor image
  ARM: dts: msm: remap PCIe BDF to IOMMU SID for sm8150-sdx50m
  qseecom: fix kclient free issue in qseecom_remove
  net: sockev: fix uninitialized data leak into userspace
  msm: vidc: Support roi delta qp per mb
  msm: msm_bus: Use appropriate data type
  Revert "msm: vidc: Use work mode 2 for avc encode with width > 3840"
  soc: qcom: pil: Add support to load PIL blobs in parallel
  ARM: dts: msm: Remove redundant sm8150p board overlay files
  defconfig: qcs405: Enable fragmented gpio address space support in tlmm
  pinctrl: qcom: Dynamic detection of tile virtual address
  ARM: dts: msm: Enable only base tile mapping during probe
  defconfig: qcs405: Add perf-defconfig for qcs405
  defconfig: disable DSI parser for sa8155
  msm: kgsl: Enhance reading lm_sequence in _execute_reg_sequence()
  pinctrl: qcom: Add direct connect configuration for sdmmagpie
  msm: npu: Add 32-bit application support
  usb: dwc3-msm: Resume before notifying cable connect to PHY
  ARM: dts: msm: Remove mtp and cdp dtsi files for sm6150
  ARM: dts: msm: Add cnss node for sa8155
  drivers: irqchip: qcom: Update PDC pin data for sdmmagpie
  defconfig: Enable debug clock controller for SM6150
  ARM: dts: msm: Add the debug clock node for SM6150
  clk: qcom: qcs405: Always keep pcnoc usb2/3 clocks ON
  ARM: dts: msm: Add bluetooth node of wcnw3990 for sdm6150
  ARM: dts: msm: Add PHY clocks for SS PHY on QCS405
  usb: phy: Clean up phy-msm-ssusb driver of dead code
  scsi: ufs: fix bugs for UFS debugfs entry power_mode
  clk: qcom: Update the config_ctl and test_ctl registers for SM6150
  clk: qcom: clk-rcg2: Allow DFS clients to scale the RCG while its enabled
  esoc: Move polling of the gpio from an interrupt context
  msm: kgsl: Fix GPU recovery on a640
  msm: adsprpc: cache buffers only of small sizes
  ANDROID: sched/fair: return idle CPU immediately for prefer_idle
  ANDROID: sched/fair: add idle state filter to prefer_idle case
  ANDROID: sched/fair: remove order from CPU selection
  ANDROID: sched/fair: unify spare capacity calculation
  netfilter: Change %p to %pK in debug messages
  msm: sps: Suppress bind/unbind attributes
  icnss: Add a flag to indicare FW rejuvenate
  ARM: dts: msm: Add support of CSRA66X0 for QCS405 platform
  dmaengine: gpi: Set dma mask to 64
  Coresight: disable cache feature for tmc controller
  defconfig: qcs405: Enable miscellaneous configs for QCS405
  devfreq: suppress platform driver bind / unbind feature
  ARM: dts: msm: Update thermal zone TSENS mappings for QCS405
  arm64: msm: Add support for uncompressed kernel image
  soc: qcom: Enable SWAO mem dump
  msm: vidc: Add enc pixel fmt constraint entry for NV12_512
  msm: vidc: Add NV12_512 support for encoder
  ANDROID:sched/fair: prefer energy efficient CPUs for !prefer_idle tasks
  ANDROID: sched/fair: fix CPU selection for non latency sensitive tasks
  msm: ipa: map MHI doorbells to IPA uC
  ARM: dts: carve out space from IPA uC iova
  sched/fair: improve big task placement
  sched/fair: do not reset target_capacity
  sched/walt: improve the scheduler
  icnss: report fail to send modem shutdown message only when ret is negative
  usb: pd: Update dual_role_usb in case of legacy cable
  msm: ipa3: Embellish IPA/GSI support for IPA 4.5 emulation system
  mmc: sdhci-msm: Add new workqueue for pm qos unvoting
  defconfig: sm6150: Enable QG, SMB1390 and SMB1355 drivers
  ARM: dts: msm: Add SPDIF support for qcs405
  ARM: dts: msm: Update cpu frequencies in energy-costs for QCS405
  ARM: dts: msm: EMAC changes for qcs405
  defconfig: qcs405: Enable AR803x PHY config
  ARM: dts: qcom: Update sdhc vdd-io voltage level for qcs405
  qseecom: abort all listener threads before listener unregistration
  ARM: dts: msm: add spss_utils to sm8150 v2
  ARM: dts: msm: modify sid values for rotator for SM8150 v2
  ARM: dts: Add NPU configuration for sm8150-v2
  msm: kgsl: Enable IFPC on A640 v1
  msm: kgsl: Increase the fenced write timeout
  staging: android: ion: rate limit warning in ion_buffer_kmap_put
  defconfig: sm8150: Enable CONFIG_MEMCG
  lowmemorykiller: Account for ZONE_MOVEABLE
  msm: npu: Fix SSR issue due to race condition
  arm64: dts: msm: Add correct current loads for WCN3990
  ARM: dts: msm: Update the bus topology for SM6150
  cpuidle: lpm-levels: Correctly log failure to enter LPM
  ARM: dts: msm: Add GPU PIL properties for sm6150
  Revert "ARM: dts: msm: enable display rsc for sm8150"
  USB: dwc3-msm: Perform DBM config/unconfig under spinlock protection
  USB: dwc3-msm: Disable Update xfer for DBM on ep disable or dequeue
  USB: dwc3-msm: Disable DBM endpoint in msm_ep_unconfig if no req queued
  USB: dwc3-msm: Check endpoint status and request queued or not first
  sound: usb: Populate QMI request receive time stamp
  USB: dwc3-msm: Initialize DBM ep before BAM pipe reset
  sched: kill sched_use_walt_cpu_{task_}util sysctl knobs
  usb: core: Drive resume for 20ms for devices behind external hub
  arm64: Update dram end address while randomizing base
  perf: protect group_leader from races that cause ctx double-free
  sched/fair: fix a problem with boost placement
  sched/walt: improve the scheduler
  sched: fastpath for prev_cpu
  esoc: Set default boot fail action to panic
  power: qpnp-fg-gen4: Update rslow_age_scale_fn for PM8150B V2
  platform: qpnp-revid: Add revision 2.0 for PM8150B
  stop_machine: Disable preemption after queueing stopper threads
  ARM: dts: msm: Add VADC and ADC_TM support for SM6150
  ARM: dts: msm: Add support for sm8150 v2 target
  msm: camera: icp: icp log modification
  msm: camera: Return IRQ_NONE from irq handlers
  msm: kgsl: Enable Content Protection for A608 GPU
  power: smb5: Add support of PM6150 charger
  msm: camera: debugfs to update clk rates dynamically
  msm: camera: Improve logging capability in kmd drivers
  msm: camera: cci: Fix error check
  ARM: dts: msm: Add src clk name & control tags for sm8150
  msm: camera: isp: Support of Y8 format for IFE FD port
  msm: camera: Dynamically enable CSID SOF irq
  msm: camera: cpas: Update logic for reading hw version at runtime
  msm: camera: isp: Fix the return value for CDM timeout error
  msm: camera: isp: Configure WM10 as LSB aligned for PDAF
  ARM: dts: msm: Enable gpu-quirk-secvid-set-once for sm8150
  msm: kgsl: Write TSB registers after turning on power
  msm: kgsl: Do not invoke loading of GPU ZAP shader

Change-Id: Ibede9685517e3a29b6f40f359166382b459b5cf3
Signed-off-by: Namratha Siddappa <namratha@codeaurora.org>