Merge commit '6f516dcd' into dev/msm-4.14-display

* commit '6f516dcd':
  ARM: dts: msm: Bring all board specific changes to common file for QCS610
  msm: camera: Allow applying request if congestion comes
  ARM: dts: msm: Add initial dts support for QCM6125
  soc: qcom: socinfo: Add support for QCM6125/QCS6125 soc-id
  ARM: dts: qcom: Add support for POMS on sim-video-panel
  arm64: dts: msm: Add dt entry for manual fw loading
  ARM: dts: msm: Add restart driver to sdm429
  usb: pd: Use break instead of return after soft reset is done
  ARM: dts: msm: remove default SA6155 DP pinctrl
  ARM: dts: msm: Enable USB type-C analog audio on SDM660
  net-ipv6-ndisc: add support for 'PREF64' dns64 prefix identifier
  fbdev: msm: call pxl clk unprepare during suspend
  msm: vidc: Fix in deciding power mode
  dma-buf: fill dmabuf->name in dma_buf_export
  ARM: dts: msm: Include camera sensor DTSi file for QCS410
  USB: gadget: Add a print for Boot marker KPI
  msm: camera: isp: Add trace event in case of irq delay detected
  msm: camera: csiphy: Clear secure phy flags on release
  msm: ais: fix csid fatal error issue
  ANDROID: net: bpf: permit redirect from ingress L3 to egress L2 devices at near max mtu
  ARM: dts: msm: Correct the spi pinctrl active node name
  ARM: dts: msm: Enable sdx_ext_ipc and set policy to NOP in sa515m
  sched: Fix out of bounds issue in for_each_cluster macro
  drivers: soc: sdx_ext_ipc: Add option to change default policy
  msm: adsprpc: Fix array index underflow problem
  power: smb1398: Fix array index out of bounds error
  bootkpi: Add KPI Marker for System Resume
  Revert "Kconfig: Add menu choice option to reclaim virtual memory"
  msm: ipa3: Add max PDN  num based on hardware version
  ARM: dts: qcom: Add device nodes for second AFE rx and proxy tx devices
  msm: ipa: update MHI event id logic
  defconfig: qcs610-minimal-perf: enable I2C support config
  defconfig: qcs610-minimal-perf: enable security config
  defconfig: qcs610-minimal-perf: enable I2C config
  cnss: Migrate to upstream adc_tm interface for wlan vbat feature
  wcnss: Migrate from SMD to upstream rpmsg
  msm: ipa: eth: Provide exception stats in lan_rx_skb trace
  msm: ipa: eth: Fix double free of dropped exception skbs
  spi: spi-geni-qcom : Don't configure SPI WORD LEN for SPI Slave
  coresight: Add ports and port child node check in get_ports function
  ARM: dts: msm: Add support for sdxprairie-v2-dsda-cdp
  msm:ipa:mhi: fix the number of max channel for mhi
  Revert "ARM: dts: msm: remove 2nd DP and eDP from sa8195p"
  msm: ipa3: Fix to enable the HOLB during enable wdi pipe
  usb: dwc3: gadget: Avoid spuriously printing NO_PULLUP in log
  ARM: dts: msm: Fix extcon property issue for SDM429
  ARM: dts: disable LDO 1,2,7 and 10 not required
  defconfig: sa2150p: remove support for HID devices
  ARM: dts: msm: Disable RSCC on sa8155
  ARM: dts: msm: Disable RSCC on sa6155
  ARM: dts: msm: include correct dtsi for sa8195p-v2-adp-air-overlay.dts
  msm: camera: Correct GPIO values for IRCUT On/Off function
  ARM64: DTS: qcs610: put VA macro node on top of other macros
  Revert "ARM: dts: msm: fix NFC device probe issue for sdm660"
  defconfig: sa2150: remove atheros 802.11ac wireless cards support
  defconfig: sa2150p: remove user space SPI device driver support
  ARM: dts: sa2150p: disable nodes for graphics support not needed
  defconfig: sa2150p: remove usb mass storage support
  defconfig: sa2150p: remove NFC driver
  defconfig: sa2150p: remove 3D Graphics driver
  clk: qcom: gcc: Add support for 80KHz and 100KHz for gp clocks
  defconfig: sa2150p: remove unused regulator for APC
  defconfig: sa2150p: remove cnss driver from build
  net: stmmac: get set wol & duplicate message fix
  ARM: dts: msm: add support of DP PHY bond mode for SA8195p
  ARM: dts: msm: added 2nd DP and eDP for SA8195p
  ARM: dts: msm: Add SPS node for sdmshrike
  soc: qcom: hab: fix memory leak
  USB: phy: msm: Register extcon callbacks in usb_add_phy()
  Revert "ARM: dts: msm: Add support for SDX55 V2 TTP CPE platform"
  mm: release the spinlock on zap_pte_range
  ARM: dts: qcom: resolve undefined node for SDM429 WTP
  msm: ais: fix csid error event callback propagation
  ARM: msm: dts: enable touch node for SDM429W+BG targets
  rpm-smd: Remove redundant spinlocks which are not required
  ARM: dts: qcom: Modify sleep state config for SPI
  defconfig: Enable the SPM driver for sdm429
  drivers: irqchip: qcom: Add mpm pin data for sdm429
  ARM: dts: msm: Add LPM device nodes for sdm429
  ARM: dts: msm: Add MPM interrupt controller for sdm429
  ARM: dts: msm: Enable adsp vdd restriction cooling device for sa2150p
  defconfig: Enable CONFIG_PSI
  ARM: dts: msm: config primary tdm as pcm on auto platforms
  usb: gadget: f_mbim: Set bnotification type in mbim_write
  drivers: usb: gadget: add minor fixes
  Add S2R and S2D support in KMD
  drm/bridge: add anx7625 to drm device pm link
  msm: v4l2loopback: to create V4L2 loopback devices
  ARM: dts: msm: add hgsl to sa8195 vm for GPU doorbell

Change-Id: I0f41559725a5a112681fa66a9e08c962d8bb1f5e
Signed-off-by: ckosuru <kosuru@codeaurora.org>