Merge "Ignore AAC bitrate from the A2DP Sink device if below a threshold"

  result_config_cie.variableBitRateSupport =

      a2dp_aac_caps.variableBitRateSupport;

  // Set the bit rate to the smaller of the local and peer bit rate

  // However, make sure the bit rate doesn't go beyond a certain threshold

  if (sink_info_cie.bitRate == 0) {

    // NOTE: Some devices report bitRate of zero - in that case use our bitRate

  // Set the bit rate as follows:

  // 1. If the Sink device reports a bogus bit rate

  //    (bitRate < A2DP_AAC_MIN_BITRATE), then use the bit rate from our

  //    configuration. Examples of observed bogus bit rates are zero

  //    and 24576.

  // 2. If the Sink device reports valid bit rate

  //    (bitRate >= A2DP_AAC_MIN_BITRATE), then use the smaller

  //    of the Sink device's bit rate and the bit rate from our configuration.

  // In either case, the actual streaming bit rate will also consider the MTU.

  if (sink_info_cie.bitRate < A2DP_AAC_MIN_BITRATE) {

    // Bogus bit rate

    result_config_cie.bitRate = a2dp_aac_caps.bitRate;

  } else {

    result_config_cie.bitRate =

        std::min(a2dp_aac_caps.bitRate, sink_info_cie.bitRate);

    result_config_cie.bitRate = std::max(

        result_config_cie.bitRate, static_cast<uint32_t>(A2DP_AAC_MIN_BITRATE));

  }

  //