Merge "Split ANGLE supported and enabled into different Makefiles." into udc-dev

#

# Copyright 2023 The Android Open-Source Project

#

# Licensed under the Apache License, Version 2.0 (the "License");

# you may not use this file except in compliance with the License.

# You may obtain a copy of the License at

#

#      http://www.apache.org/licenses/LICENSE-2.0

#

# Unless required by applicable law or agreed to in writing, software

# distributed under the License is distributed on an "AS IS" BASIS,

# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.

# See the License for the specific language governing permissions and

# limitations under the License.

#

# To enable ANGLE as the default system GLES drivers, add

# $(call inherit-product, $(SRC_TARGET_DIR)/product/angle_enabled.mk) to the Makefile.

$(call inherit-product, $(SRC_TARGET_DIR)/product/angle_supported.mk)

PRODUCT_VENDOR_PROPERTIES += \

    persist.graphics.egl=angle

# limitations under the License.

#

# To include ANGLE drivers into the build, add

# $(call inherit-product, $(SRC_TARGET_DIR)/product/angle.mk) to the Makefile.

# To include ANGLE into the image build, add

# $(call inherit-product, $(SRC_TARGET_DIR)/product/angle_supported.mk) to the Makefile.

# By default, this will allow ANGLE binaries to coexist with native GLES drivers.

PRODUCT_PACKAGES += \

    libEGL_angle \

    libGLESv2_angle

# Set ro.gfx.angle.supported based on if ANGLE is installed in vendor partition

PRODUCT_VENDOR_PROPERTIES := ro.gfx.angle.supported=true

PRODUCT_VENDOR_PROPERTIES += ro.gfx.angle.supported=true