Merge commit '06b6c7ac' into dev/msm-4.14-display

* commit '06b6c7ac':
  Revert "defconfig: qcs405: enable MHI host stack for qcs405"
  drivers: iommu: dump testbus output on tlb_sync timeouts
  iommu: arm-smmu: add option to distinguish testbus implementations
  ARM: dts: msm: Add touch support for QRD atoll target
  iommu: arm-smmu: add testbus support for smmuv500
  ARM: dts: msm: Update cpuss dump sizes for Atoll
  ARM: dts: msm: Add gpu bandwidth table for atoll
  ARM: dts: qcom: Add camera nodes for atoll qrd device
  mhi: core: wakeup waiters if early error is received
  ARM: dts: msm: Remove multiple display port changes for atoll
  defconfig: msm: Enable additional configs for atoll
  ARM: dts: qcom: Add iommu bus voting details for SMMU level
  ARM: dts: msm: Update GPU fmax for atoll
  power: qpnp-qg: Fix kernel memory corruption error in qg_device_read
  msm: ep_pcie: Increase BME timeout
  defconfig: change BLK_DEV_LOOP_MIN_COUNT's value for SM6150
  ARM: dts: qcom: Add pinctrl of tof camera for atoll
  ARM: dts: msm: Add audio support for wcd937x codec
  cnss2: set iova_stop to U64_MAX
  ARM: dts: msm: Add audio support for atoll target
  staging: android: ion: rate limit warning in ion_sgl_sync_range
  defconfig: msm: Enable overlay fs support for atoll
  ARM: dts: msm: Add GPU power levels support to atoll
  ARM: dts: qcom: Enable camera sensors in IDP for atoll
  diag: Initialize peripheral mask properly before log switch
  ARM: dts: msm: Add audio over usbc platform for atoll
  ARM: dts: msm: Add support for BT in atoll platform
  ARM: dts: msm: Add audio codec wcd937x platform for atoll SoC
  ARM: dts: msm: add regulator and clock for pil nodes
  ARM: dts: msm: Enable UFS, eMMC and SDcard drivers on ATOLL
  ARM: dts: qcom: enable audio on QCS404
  ARM: dts: msm: Add ATP platform support for atoll
  ARM: dts: msm: Add qfprom device node for Atoll
  Arm: dts: Add devfreq node for Atoll
  pinctrl: qcom: Update direct connect configuration for atoll
  phy: msm: qusb: Support reading of efuse value from two regs
  ARM: dts: msm: Disable IO-Coherent allocation for SDXPRAIRIE
  msm: camera: isp: Added PPI driver functionality
  ARM: dts: msm: Add touch support for atoll target
  ARM: dts: msm: add dsi dt node for atoll target
  ARM: dts: qcom: Enable phy regulators for atoll
  ARM: dts: qcom: Add csiphy, cci for atoll
  ARM: dts: msm: Add camera sensor nodes for atoll
  drm/msm/dsi-staging: add support for controller version 2.4
  msm: isp: update the software irq mask
  ARM: dts: msm: add display dt node for atoll target
  ARM: dts: msm: Include dtsi file for v150_110 camera
  arm64: cpu_errata: Add ARM erratum 1188873 for Kryo 4G
  ARM: dts: qcom: Add cci, sensor pinctrl gpio for atoll
  arm64: arch_timer: Add workaround for ARM erratum 1188873
  Revert "net: qrtr: Send HELLO message on endpoint register"
  usb: dwc3: Queue sm_work only on sm_usb_wq
  ARM: dts: msm: Correct USB audio stream iommu SID for atoll
  msm: ipa3: Update channel start as success in flow control state
  defconfig: Enable PM8008 regulator driver for atoll
  ARM: dts: msm: Add charger, QG and VOL_UP configuration for atoll
  ARM: dts: msm: Add QG profile for ATL466271_3300mAh battery
  ARM: dts: msm: Add icnss node on atoll
  msm: camera: Add csiphy version for atoll
  ARM: dts: msm: Correct efuse register address on atoll
  ARM: dts: msm: Remove pm-qos-latency from atoll
  ARM: dts: msm: Pass eud as extcon device for USB on atoll
  ARM: dts: msm: Add AHB-IB voting bandwidth to bring up v150_110 camera
  msm: camera: cpas: Add cpas support for camera v150_110 platform
  ARM: dts: msm: Add PPI clock sources to bring up v150_110 camera
  ARM: dts: msm: Update bus interconnect topology for ATOLL
  ARM: dts: msm: Add qseecom heap for atoll
  ARM: dts: msm: Update the clock controller and GDSC nodes for ATOLL
  defconfig: enable synaptics_tcm driver for atoll target
  ARM: dts: msm: Add proxy client node for ATOLL
  defconfig: Enable clock controller drivers for ATOLL
  clk: qcom: Add GPUCC clock driver for ATOLL
  clk: qcom: Add debug clock controller for ATOLL
  msm: ipa: Support for offload autostart in offload sub-system
  clk: qcom: Add support for NPUCC driver for ATOLL
  clk: qcom: Add display clock driver for ATOLL
  clk: qcom: Add video clock driver for ATOLL
  clk: qcom: Add camera clock driver for ATOLL
  clk: qcom: Add GCC clock driver for ATOLL
  msm: Fix address space violation in I/O accessors
  ARM: dts: msm: Add Bluetooth device node for SA6155p VM
  ARM: dts: msm: enable qupv3_se7_4uart in SA6155p VM
  drivers: esoc: Set crash status after modem status goes low
  esoc: Protect the crash shutdown path against reboot notifier

Change-Id: I843a0a6e569672f625c75a445d220e77289a06b1
Signed-off-by: Saikumar <saikk@codeaurora.org>