Merge commit 'AU287' into dev/msm-4.14-display

* commit '6f808a5a':
  Revert "ARM: dts: msm: enable dma-coherent attribute for UFS on SM8150"
  ARM: dts: msm: Reduce cycles between ESR pulses on SM8150 MTP
  power: qpnp-fg-gen4: Reduce ESR fast calibration time to 50s
  net: core: neighbour: Change the print format for addresses
  defconfig: sm6150: Enable clock controller drivers for SM6150
  ARM: dts: msm: Add icnss node on SM6150
  ARM: dts: msm: Update regulator handles for VDD_CX/VDD_MX for SM6150
  ARM: dts: msm: Update the clock_dispcc node on SM6150
  clk: qcom: Add display clock driver for SM6150
  ARM: dts: msm: Update the clock_camcc node on SM6150
  ARM: dts: msm: Add dtsi entries of USB for SM6150
  power: qpnp-qg: Add handling for SYS_SOC
  clk: qcom: camcc: Add support for 12MHz for mclk
  msm: vidc: skip sending old resolution buffers
  icnss: print return value for modem_shutdown_msg
  ARM: dts: msm: enable IP HW CH by default and disable for sm8150-sdx50
  soc: eud: Fix event handling for input suspend/unsuspend
  msm: kgsl: Add support for PDC register subsections
  net: cnss2: Add snapshot of CNSS2 driver
  power: smb1355: Fix multiple I2C addr issue
  phy: qcom-ufs: Update UFS PHY calibration sequence
  ARM: dts: msm: limit number of fastrpc sessions on SLPI for 8150
  sched/fair: fix issue with max_capacity
  ARM: dts: msm: reconfigure sdx50 memory access based on AC policy
  msm: adsprpc: disable bind/unbind of fastrpc driver from userspace
  rpmsg: glink: spi: Fix use after free of channel refcount
  rpmsg: glink: spi: Set tail pointer to 0 at end of FIFO
  mhi: controller: qcom: add support for sdxprairie device
  mhi: controller: qcom: add sysfs control for mhi power
  wil6210: fix RX buffers release and unmap
  wil6210: prevent usage of tx ring 0 for eDMA
  wil6210: allocate rx reorder buffer only if rx reorder is enabled
  ARM: dts: msm: Associate address with clock controller nodes for SM6150
  clk: qcom: clk-cpu-qcs405: Add support for vdd_hf_pll regulator
  clk: qcom: Kconfig: Add support to select GDSC flag for SM6150
  ARM: dts: msm: Increase ADSP ion heap by 4 MB for qcs405
  soc: qcom: dccv2: fix the Linked_List default value
  ARM: dts: msm: enable ETR SG as default and DCC with LL1 on qcs405
  soc: qcom: rpm-smd-debug: Fix potential memory leaks
  ARM: dts: msm: add bluetooth chip device node for sa8155
  power: qpnp-qg: Update GOOD_OCV after clearing the old data
  power: qpnp-fg-gen4: Fix esr_delta bounding error
  sdcardfs: Fix the format prints in sdcardfs
  ARM: dts: update PCIe PHY base address for sm8150 v2
  net: qrtr: Add non blocking option for tx_resume
  net: qrtr: Send BYE message for all nodes on ept
  ARM: dts: msm: Add GPU configuration for sm8150-v2
  power: smb5: Set OTG mode current limit
  ARM: dts: msm: Add labels for TDM nodes
  pinctrl: qcom: Use correct offset for UFS_RESET_CTL register
  soc: qcom: use spinlock with irq save in CDSPRM module
  qcs405_defconfig: Enable the tzlog driver.
  defconfig: qcs405: Enable Qseecom driver
  ARM: dts: msm: Change DCC cur list for sm8150
  clk: qcom: clk-cpu-osm: Add OSM clock driver support for SM6150
  input: synaptics_dsx: Propagating security fixes from msm-4.9
  ARM: dts: qcom: Add sdhc1/sdhc2 for sm6150 mtp/cdp
  clk: qcom: Add camera clock driver for SM6150
  ARM: dts: msm: Disable vibrator overdrive for pm6150
  ARM: dts: msm: Add cdsp pil node for sdmmagpie
  mhi: controller: qcom: add debug mode parameter for debug control
  ARM: dts: msm: add mhi host support for sm8150 PCIe RC0
  cnss_prealloc: Remove excessive warnings in cnss_prealloc driver
  ARM: dts: msm: Move audio overlay device tree file on SM8150 target
  rmnet: fix tx rmnet stats to work with UL aggregation
  Revert "sched/sysctl: check for min/max values for sched_{up,down}_migrate knobs"
  icnss: Change QMI timeout to 10sec
  power: qpnp-qg: Update VBAT_LOW fifo_length handling
  sound: usb: use er_mapped flag to indicate event ring mapped or not
  lowmemorykiller: fix cma accounting
  clk: qcom: Remove write update to EMAC_MISC register
  ARM: dts: msm: Enable QoS programming for qcs405
  defconfig: Enable kernel low memory killer for sdmsteppe
  ARM: dts: msm: Add sleep clock for HS PHY on QCS405
  ARM: dts: msm: add PMIC devices for sdmmagpie
  defconfig: msm: Enable CXIP LM cooling device driver for SM6150
  drivers: thermal: Add support for CX IPeak LM cooling device
  socinfo: Add support for ADP platform
  ARM: dts: msm: disable L0s for PCIe0 and PCIe1 on sm8150
  rtc: Disable alarm irq if alarm time is in the past
  defconfig: qcs405: Enable smp2p sleep state for qcs405
  coresight: tpdm: Don't disable clk and regulator when enabled
  power: qpnp-qg: Update ESR estimation parameters
  power: qpnp-qg: Move GOOD_OCV irq handling to suspend/resume
  drivers: net: rmnet: Power collapse UL change
  iommu: ignore scm_call return if SMC_ID not supported
  iommu: arm-smmu: Preallocate memory for map operation
  iommu: arm-smmu: Move most memory allocations to GFP_KERNEL
  dma-mapping: fix build when !CONFIG_ARM_SMMU
  iommu: arm-smmu: Program TTBR1 to a zero page
  iommu: arm-smmu: fix KW issues
  iommu: iommu-debug: limit memory address exposure
  iommu: iommu-debug: cleanup iommu debug
  iommu: Remove config dependency
  ARM: dts: msm: Add ADC_TM thermal nodes on SM8150
  ARM: dts: msm: Enable ADC_TM on PM8150B
  thermal: adc_tm: Update channel assignments for PM8150B 1.0
  soc: qcom: Fix module cleanup error in dfc
  iio: adc: Update reading USB_IN_V channel
  power: smb5-lib: Fix low USB input current limit issue
  defconfig: Enable USB configfs and function drivers
  defconfig: arm64: Enable ICE based HW FBE on sa8155
  net: bridge: Fix merge error
  msm: gsi: gsi channel mode switch spinlock correction
  msm: npu: Add firmware debug mode support
  ARM: dts: msm: enable display rsc for sa8155
  msm: ipa4: Update IPA_CFG registers for IPA4.5
  ARM: dts: msm: Add Qseecom node and Qseecom heap for qcs405
  msm: kgsl: Add a check before requesting GPU keepalive
  ARM: dts: msm: Enable NTAG device node for QCS405
  defconfig: Enable CONFIG_CMA_DEBUGFS for sdmsteppe
  ARM: dts: msm: Optimize NPU TPDM clk config for sm8150
  msm: vidc: Use data corrupt flag instead of error flag
  perf: don't leave group_entry on sibling list (use-after-free)
  fs: ext4: disable support for fallocate FALLOC_FL_PUNCH_HOLE
  msm: adsprpc: validate remote parameters pointer
  msm: adsprpc: validate dma physical address after mapping
  iommu: arm-smmu: add tlbi traces
  iommu: arm-smmu: modify iommu_errata_tlbi trace events
  iommu: dma-mapping-fast: Add standard ftrace events
  iommu: Expand ftrace events
  iommu: dma-mapping-fast: Fix error code for dma_map_sg
  iommu: fix smmu_secure_pool access list after free issue
  iommu: arm-smmu: Add smmu init latency measurement
  iommu: iommu-debug: Fix duplicate iommu_attachment entries
  iommu: arm-smmu: Fix locking issue
  Revert "iommu/io-pgtable-arm: Unmap and free table when overwriting with block"
  ARM: dts: msm: Enable UFS support on sm6150 IDP platform
  ARM: dts: msm: Add address base for swr on qcs405
  ARM: dts: msm: Correct GPU iommu protection range for SM8150
  clk: qcom: debugcc-qcs405: Update CPU measure node
  msm: kgsl: Enable IO coherency for A640
  ARM: dts: msm: add PM6150 PD PHY device
  clk: qcom: Update freq plan and FMAX corners for few GCC clocks
  leds: qpnp-vibrator-ldo: disable vibrator in suspend path
  qseecom: check if app is blocked when unloading app
  hdcp_qseecom: updating error codes
  msm: vidc: extend AVC level query support upto 6.2
  msm: vidc: extend AVC level support upto 6.2
  ARM: dts: msm: enable smmu s1 in wlan CBs
  msm: vidc: Correct buffer counts for secondary output mode
  timers, sched/clock: Hook into s2idle freeze path
  smp: Wake up all idle CPUs when suspending to idle
  smp: Do not wake up all idle CPUs
  drivers: cpuidle: lpm-levels: Support s2idle
  drivers: cpuidle: lpm-levels: Remove hotplug checking
  msm: ipa: fix the ipa-hw rules not clean
  input: touchpanel: Add Synaptics latest version 2.7 touchpanel driver
  msm: vidc: correctly calculate core workload
  usb: core: Add support to handle multi config audio device
  msm: kgsl: Keep a list of perfcounters per file descriptor
  ARM: dts: msm: update cpu core frequencies for qcs405 target
  msm: kgsl: Fix typo in a6xx snapshot
  msm: kgsl: Fix reading lm_sequence in _execute_reg_sequence()
  ip: limit use of gso_size to udp
  ARM: dts: msm: enable dma-coherent attribute for UFS on SM8150
  drivers: thermal: bcl_pmic5: Incorporate thermometer encoding
  esoc: Check for modem status LOW prior to error handling

Change-Id: I86ff9d6fc5dd1dfe8e0ae29a10135f6b12034c01
Signed-off-by: Namratha Siddappa <namratha@codeaurora.org>