Merge remote-tracking branch 'quic/dev/msm-4.14-display' into msm-4.14

* quic/dev/msm-4.14-display:
  drm/msm/sde: deprecate force panel dead from connector
  drm/msm/dsi-staging: add software simulation of esd failure
  ARM: dts: msm: enable ulps for various displays on SM8150
  drm/msm/sde: add sde_hw_ctl ops for peripheral flush
  drm/msm: extract compression ratio and widebus mode from connector
  drm/msm/sde: decouple sde_fence_context from sde_connector
  drm/msm/dsi-staging: avoid ulps entry while esd recovery is pending
  drm/msm/dp: fix timeslot programming error for mst streams
  drm/msm/sde: Add debugfs support for fence info dump
  drm/msm/dsi-staging: add null check for user length
  msm/drm/sde: handle dynamic mode switch issue
  drm/msm/dsi-staging: alter length to avoid stepping out of bounds
  drm/msm/dsi-staging: fix potential out of bounds memory accesses
  drm/msm/dsi-staging: skip DCS command tx during recovery
  drm/msm/dsi-staging: add qsync/avr support in dsi controller
  drm/msm/dsi-staging: Allocate correct size of memory
  drm/msm/dp: fix error checking for memory allocations
  drm/msm/sde: reconstruct the connector info for sde_crtc_state
  drm/msm/dp: add ch alloc/dealloc for mst simulator panel
  drm/msm/sde: move UBWC error logging to frame event callback
  msm/sde/rotator: Add rev checks for sm6150
  drm/msm/sde: Add rev checks for sm6150 target
  drm/msm/dp: disable back-pressure before starting stream
  drm/msm/dsi-staging: tie up dsi irq control to core clock
  drm/msm/dp: reset post_open flag on cable disconnect
  drm/msm/dp: Add gpio hpd support for DP
  drm/msm/dp: update stream on sequence in mst mode
  drm/msm/sde: update CWB detection logic
  drm/msm/sde: remove thread flush request for same thread
  drm/msm: update msg log level for edid cea ext check
  drm/msm/sde: fix pp_4 and pp_5 done irq register enable
  drm/msm/dp: fix handling interleaved hotplug events
  dmr/msm/sde: propagate correct fence_event to sde_fence_signal
  drm/msm/sde: decrement pending_retire_fence_cnt on timeout
  clk: qcom: add common clock framework support for 14nm DSI PHY
  drm: msm: sde: Add support for Qseed3Lite
  drm/msm/sde: update qsync calculation for command mode display
  drm/msm/sde: add pending retire fence count to event logs

Change-Id: Ic9cbee831e4d0707bbaf0417b32f37f184c8fcac
Signed-off-by: Namratha Siddappa <namratha@codeaurora.org>