Merge "ARM: dts: msm: Modify i2c_3 config for LED driver" (d7025da4) · Commits · e / devices / android_kernel_xiaomi_markw

arch/arm/boot/dts/qcom/apq8009-mtp-wcd9326-excelpoint-refboard.dts

+50 −4

Original line number	Diff line number	Diff line
		@@ -96,6 +96,20 @@
		bias-pull-up;
		};
		};

		pca9956b_reset_gpio_on: pca9956b_reset_gpio_on {
		mux {
		pins = "gpio35";
		function = "spare";
		};

		config {
		pins = "gpio35";
		drive-strength = <2>;
		bias-pull-up;
		output-high;
		};
		};
		};

		&soc {
		@@ -120,6 +134,30 @@
		"SpkrRight IN", "SPK2 OUT";
		};

		i2c_3: i2c@78b7000 { /* BLSP1 QUP3 */
		compatible = "qcom,i2c-msm-v2";
		#address-cells = <1>;
		#size-cells = <0>;
		reg-names = "qup_phys_addr";
		reg = <0x78b7000 0x1000>;
		interrupt-names = "qup_irq";
		interrupts = <0 97 0>;
		clocks = <&clock_gcc clk_gcc_blsp1_ahb_clk>,
		<&clock_gcc clk_gcc_blsp1_qup3_i2c_apps_clk>;
		clock-names = "iface_clk", "core_clk";
		qcom,clk-freq-out = <100000>;
		qcom,clk-freq-in = <19200000>;
		pinctrl-names = "i2c_active", "i2c_sleep";
		pinctrl-0 = <&i2c_3_active &pca9956b_reset_gpio_on>;
		pinctrl-1 = <&i2c_3_sleep>;
		qcom,noise-rjct-scl = <0>;
		qcom,noise-rjct-sda = <0>;
		dmas = <&dma_blsp1 8 64 0x20000020 0x20>,
		<&dma_blsp1 9 32 0x20000020 0x20>;
		dma-names = "tx", "rx";
		qcom,master-id = <86>;
		};

		i2c@78b8000 {
		wcd9xxx_codec@d {
		qcom,wcd9xxx-mic-tristate;
		@@ -370,19 +408,27 @@
		};

		&i2c_3 {
		qcom,camera@0 {
		qcom,actuator@0 {
		status = "disabled";
		};

		qcom,camera@1 {
		qcom,eeprom@6c {
		status = "disabled";
		};

		qcom,camera@42 {
		led_flash0: qcom,led-flash@60 {
		status = "disabled";
		};

		led_flash0: qcom,led-flash@60 {
		qcom,camera@0 {
		status = "disabled";
		};

		qcom,camera@1 {
		status = "disabled";
		};

		qcom,camera@42 {
		status = "disabled";
		};
		};