Commit bcc67771 authored Jan 05, 2011 by Shawn Guo Committed by David S. Miller Jan 09, 2011

net/fec: improve pm for better suspend/resume



The following commit made a fix to use fec_enet_open/fec_enet_close
over fec_enet_init/fec_stop for suspend/resume, because fec_enet_init
does not allow to have a working network interface at resume.

  e3fe8558
  net/fec: fix pm to survive to suspend/resume

This fix works for i.mx/mxc fec controller, but fails on mx28 fec
which gets a different interrupt logic design. On i.mx fec, interrupt
can be triggered even bit ETHER_EN of ECR register is not set. But
on mx28 fec, ETHER_EN must be set to get interrupt work. Meanwhile,
MII interrupt is mandatory to resume the driver, because MDIO
read/write changed to interrupt mode by commit below.

  97b72e43
  fec: use interrupt for MDIO completion indication

fec_restart/fec_stop comes out as the solution working for both
cases.

Signed-off-by: Shawn Guo <shawn.guo@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

parent 49da97dc

drivers/net/fec.c

+8 −4

Original line number	Diff line number	Diff line
		@@ -1372,8 +1372,10 @@ fec_suspend(struct device *dev)

		if (ndev) {
		fep = netdev_priv(ndev);
		if (netif_running(ndev))
		fec_enet_close(ndev);
		if (netif_running(ndev)) {
		fec_stop(ndev);
		netif_device_detach(ndev);
		}
		clk_disable(fep->clk);
		}
		return 0;
		@@ -1388,8 +1390,10 @@ fec_resume(struct device *dev)
		if (ndev) {
		fep = netdev_priv(ndev);
		clk_enable(fep->clk);
		if (netif_running(ndev))
		fec_enet_open(ndev);
		if (netif_running(ndev)) {
		fec_restart(ndev, fep->full_duplex);
		netif_device_attach(ndev);
		}
		}
		return 0;
		}