Donate to e Foundation | Murena handsets with /e/OS | Own a part of Murena! Learn more

Commit 3a087b21 authored by Fabian Frederick's avatar Fabian Frederick Committed by David S. Miller
Browse files

ixgbe: remove unnecessary break after goto 



Signed-off-by: default avatarFabian Frederick <fabf@skynet.be>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent a4a07624

drivers/net/ethernet/intel/ixgbe/ixgbe_82598.c

+0 −1
Original line number Diff line number Diff line
@@ -430,7 +430,6 @@ static s32 ixgbe_fc_enable_82598(struct ixgbe_hw *hw) 
		hw_dbg(hw, "Flow control param set incorrectly\n");

		ret_val = IXGBE_ERR_CONFIG;

		goto out;

		break;

	}



	/* Set 802.3x based flow control settings. */

drivers/net/ethernet/intel/ixgbe/ixgbe_82599.c

+0 −4
Original line number Diff line number Diff line
@@ -432,7 +432,6 @@ static s32 ixgbe_get_link_capabilities_82599(struct ixgbe_hw *hw, 
	default:

		status = IXGBE_ERR_LINK_SETUP;

		goto out;

		break;

	}



	if (hw->phy.multispeed_fiber) {
@@ -2035,7 +2034,6 @@ static u32 ixgbe_get_supported_physical_layer_82599(struct ixgbe_hw *hw) 
		else if (pma_pmd_10g_parallel == IXGBE_AUTOC_10G_XAUI)

			physical_layer = IXGBE_PHYSICAL_LAYER_10GBASE_XAUI;

		goto out;

		break;

	case IXGBE_AUTOC_LMS_10G_SERIAL:

		if (pma_pmd_10g_serial == IXGBE_AUTOC2_10G_KR) {

			physical_layer = IXGBE_PHYSICAL_LAYER_10GBASE_KR;
@@ -2052,10 +2050,8 @@ static u32 ixgbe_get_supported_physical_layer_82599(struct ixgbe_hw *hw) 
		if (autoc & IXGBE_AUTOC_KR_SUPP)

			physical_layer |= IXGBE_PHYSICAL_LAYER_10GBASE_KR;

		goto out;

		break;

	default:

		goto out;

		break;

	}



sfp_check:

drivers/net/ethernet/intel/ixgbe/ixgbe_common.c

+0 −2
Original line number Diff line number Diff line
@@ -216,7 +216,6 @@ static s32 ixgbe_setup_fc(struct ixgbe_hw *hw) 
		hw_dbg(hw, "Flow control param set incorrectly\n");

		ret_val = IXGBE_ERR_CONFIG;

		goto out;

		break;

	}



	if (hw->mac.type != ixgbe_mac_X540) {
@@ -2179,7 +2178,6 @@ s32 ixgbe_fc_enable_generic(struct ixgbe_hw *hw) 
		hw_dbg(hw, "Flow control param set incorrectly\n");

		ret_val = IXGBE_ERR_CONFIG;

		goto out;

		break;

	}



	/* Set 802.3x based flow control settings. */