Commit 1db3b92c authored Mar 23, 2017 by Neil Armstrong Committed by Kevin Hilman Mar 28, 2017

ARM64: dts: meson-gxbb: Add USB Hub GPIO hog

The ODroid-C2 on-board USB Hub needs to to have it's reset signal set to
high level in order to be enumerated by the USB Host Controller.

But this management must be part of the currently in-development Generic
Power Sequence patch that will allow a USB Controller driver to start and stop
a power sequence associated to the USB Bus.

In the meantime, a simple USB Hog will work to enable the USB Hub.

Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Kevin Hilman <khilman@baylibre.com>

parent 8d1b908f

arch/arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts

+15 −0

Original line number	Original line	Diff line number	Diff line
	@@ -235,6 +235,21 @@
	pinctrl-names = "default";		pinctrl-names = "default";
	};		};

			&gpio_ao {
			/*
			* WARNING: The USB Hub on the Odroid-C2 needs a reset signal
			* to be turned high in order to be detected by the USB Controller
			* This signal should be handled by a USB specific power sequence
			* in order to reset the Hub when USB bus is powered down.
			*/
			usb-hub {
			gpio-hog;
			gpios = <GPIOAO_4 GPIO_ACTIVE_HIGH>;
			output-high;
			line-name = "usb-hub-reset";
			};
			};

	&usb0_phy {		&usb0_phy {
	status = "okay";		status = "okay";
	phy-supply = <&usb_otg_pwr>;		phy-supply = <&usb_otg_pwr>;