scsi: ufs: set load before setting voltage in regulators

This sequence change is required to avoid dips in voltage
during boot-up.

Apparently, this dip is caused because in the original
sequence, the regulators are initialized in lpm mode.
And then when the load is set to high, and more current
is drawn, than is allowed in lpm, the dip is seen.

CRs-fixed: 2279027
Change-Id: Ic531a1e6788d6288071f93d5002613855c2667f5
Signed-off-by: Asutosh Das <asutoshd@codeaurora.org>
Signed-off-by: Sayali Lokhande <sayalil@codeaurora.org>