fw-api: CL 6571150 - update fw common interface files (06194c53) · Commits · e / devices / android_kernel_sony_msm8998

fw/wmi_services.h

+1 −0

Original line number	Diff line number	Diff line
		@@ -380,6 +380,7 @@ typedef enum {
		WMI_SERVICE_WPA3_FT_SAE_SUPPORT = 195, /* FW roaming support for WPA3_FT_SAE */
		WMI_SERVICE_WPA3_FT_SUITE_B_SUPPORT = 196, /* FW roaming support for WPA3_FT_SUITE_B */
		WMI_SERVICE_VOW_ENABLE=197, /* FW supports a set of features to optimize VoW performance */
		WMI_SERVICE_CFR_CAPTURE_IND_EVT_TYPE_1 = 198, /* support WMI_PEER_CFR_CAPTURE_EVENT msg */


		/***** ADD NEW SERVICES HERE *****/

fw/wmi_tlv_defs.h

+7 −0

Original line number	Diff line number	Diff line
		@@ -965,6 +965,7 @@ typedef enum {
		WMITLV_TAG_STRUC_wmi_request_wlm_stats_cmd_fixed_param,
		WMITLV_TAG_STRUC_wmi_wlm_stats_event_fixed_param,
		WMITLV_TAG_STRUC_wmi_key_material_ext,
		WMITLV_TAG_STRUC_wmi_peer_cfr_capture_event_fixed_param,
		} WMITLV_TAG_ID;

		/*
		@@ -1580,6 +1581,7 @@ typedef enum {
		OP(WMI_VDEV_GET_MWS_COEX_IDRX_STATE_EVENTID) \
		OP(WMI_VDEV_GET_MWS_COEX_ANTENNA_SHARING_STATE_EVENTID) \
		OP(WMI_WLM_STATS_EVENTID) \
		OP(WMI_PEER_CFR_CAPTURE_EVENTID) \
		/* add new EVT_LIST elements above this line */


		@@ -5280,6 +5282,11 @@ WMITLV_CREATE_PARAM_STRUC(WMI_MOTION_DET_BASE_LINE_HOST_EVENTID);
		WMITLV_ELEM(id,op,buf,len, WMITLV_TAG_STRUC_wmi_esp_estimate_event_fixed_param, wmi_esp_estimate_event_fixed_param, fixed_param, WMITLV_SIZE_FIX)
		WMITLV_CREATE_PARAM_STRUC(WMI_ESP_ESTIMATE_EVENTID);

		/* Peer CFR capture event */
		#define WMITLV_TABLE_WMI_PEER_CFR_CAPTURE_EVENTID(id,op,buf,len) \
		WMITLV_ELEM(id,op,buf,len, WMITLV_TAG_STRUC_wmi_peer_cfr_capture_event_fixed_param, wmi_peer_cfr_capture_event_fixed_param, fixed_param, WMITLV_SIZE_FIX)
		WMITLV_CREATE_PARAM_STRUC(WMI_PEER_CFR_CAPTURE_EVENTID);


		#ifdef __cplusplus
		}

fw/wmi_unified.h

+90 −5

Original line number	Diff line number	Diff line
		@@ -549,8 +549,21 @@ typedef enum {
		WMI_PEER_TID_CONFIGURATIONS_CMDID,

		/** Peer configuration for Channel Frequency Response (CFR) capture
		* of type wmi_peer_cfr_capture_cmd. The CFR capture is communicated
		* through HTT_T2H_MSG_TYPE_CFR_DUMP_COMPL_IND.
		* of type wmi_peer_cfr_capture_cmd.
		*
		* On targets that do not use the direct DMA framework,
		* completion of the CFR capture is communicated through
		* HTT_T2H_MSG_TYPE_CFR_DUMP_COMPL_IND.
		* Such targets will set WMI_SERVICE_CFR_CAPTURE_IND_MSG_TYPE_1
		* in WMI Service Ready.
		*
		* On targets that use direct DMA, completion of CFR capture is
		* communicated through WMI_PDEV_DMA_RING_BUF_RELEASE_EVENTID
		* using module ID WMI_DMA_RING_CONFIG_MODULE_RTT.
		* Such targets will set WMI_SERVICE_CFR_CAPTURE_IND_EVT_TYPE_1
		* in WMI Service Ready and enumerate WMI_DMA_RING_CONFIG_MODULE_RTT
		* in the dma_ring_caps entry of WMI_SERVICE_READY_EXT_EVENTID.
		* Additional MAC metadata is provided in WMI_PEER_CFR_CAPTURE_EVENTID.
		*/
		WMI_PEER_CFR_CAPTURE_CMDID,

		@@ -1406,6 +1419,8 @@ typedef enum {
		/** report the current tx PN for the peer */
		WMI_PEER_TX_PN_RESPONSE_EVENTID,

		WMI_PEER_CFR_CAPTURE_EVENTID,

		/* beacon/mgmt specific events */
		/** RX management frame. the entire frame is carried along with the event. */
		WMI_MGMT_RX_EVENTID = WMI_EVT_GRP_START_ID(WMI_GRP_MGMT),
		@@ -4202,6 +4217,9 @@ typedef struct {
		((int8_t) (WMI_F_MS((hdr)->rssi_chain##c, \
		WMI_UNIFIED_RSSI_CHAN_##ch)))

		#define WMI_UNIFIED_CHAIN_RSSI_GET(tlv, chain_idx, band) \
		((A_INT8) WMI_F_MS((tlv)->chain_rssi[chain_idx], WMI_UNIFIED_RSSI_CHAN_ ## band))

		typedef struct {
		/** Phy error event header */
		wmi_single_phyerr_rx_hdr hdr;
		@@ -24309,6 +24327,7 @@ typedef struct {

		typedef enum {
		WMI_DMA_RING_CONFIG_MODULE_SPECTRAL,
		WMI_DMA_RING_CONFIG_MODULE_RTT,
		} WMI_DMA_RING_SUPPORTED_MODULE;

		typedef struct {
		@@ -24413,8 +24432,8 @@ typedef struct {
		*/
		A_UINT32 paddr_lo;
		/**
		* Bits 15:0: address of data [47:32]
		* Bits 31:16: reserved
		* Bits 11:0: address of data [43:32]
		* Bits 31:12: host context data [19:0]
		*/
		A_UINT32 paddr_hi;
		} wmi_dma_buf_release_entry;
		@@ -25888,6 +25907,72 @@ typedef struct {
		#define WMI_HECAP_MAC_HTVHTTRIGRX_SET WMI_HECAP_MAC_HTVHTTRIGRX_SET_D2
		#endif /* SUPPORT_11AX_D3 */

		typedef struct {
		/** TLV tag and len; tag equals
		* WMITLV_TAG_STRUC_wmi_cfr_capture_event_fixed_param */
		A_UINT32 tlv_header;
		/* Method used to capture CFR - of type WMI_PEER_CFR_CAPTURE_METHOD */
		A_UINT32 capture_method;
		/* VDEV identifier */
		A_UINT32 vdev_id;
		/* Peer MAC address. In AP mode, this is the address of the connected peer
		* for which CFR capture is needed. In case of STA mode, this is the address
		* of the AP to which the STA is connected
		*/
		wmi_mac_addr mac_addr;
		/* primary 20 MHz channel frequency in mhz */
		A_UINT32 chan_mhz;
		/* BW of measurement - of type WMI_PEER_CFR_CAPTURE_BW */
		A_UINT32 bandwidth;
		/* phy mode WLAN_PHY_MODE of the channel defined in wlan_defs.h*/
		A_UINT32 phy_mode;
		/* Center frequency 1 in MHz*/
		A_UINT32 band_center_freq1;
		/* Center frequency 2 in MHz - valid only for 11acvht 80plus80 mode*/
		A_UINT32 band_center_freq2;
		/* Number of spatial streams */
		A_UINT32 sts_count;
		/* Bits 31:0: address of data from wmi_dma_buf_release_entry [31:0] */
		A_UINT32 correlation_info_1;
		/* Bits 11:0: address of data from wmi_dma_buf_release_entry [43:32]
		* Bits 15:12: reserved (set to 0x0)
		* Bits 31:16: hardware PPDU ID [15:0]
		*/
		A_UINT32 correlation_info_2;
		/* Bits 1:0: TX status (if any); values defined in enum
		* WMI_FRAME_TX_STATUS
		* Bits 30:2: reserved (set to 0x0)
		* Bit 31: Status of the CFR capture of the peer
		* 1 (True) - Successful; 0 (False) - Not successful
		*/
		A_UINT32 status;
		/* Timestamp in microseconds at which the CFR was captured in the hardware.
		* The clock used for this timestamp is private to the target and
		* is not visible to the host i.e., Host can interpret only the
		* relative timestamp deltas from one message to the next,
		* but can't interpret the absolute timestamp from a single message.
		*/
		A_UINT32 timestamp_us;
		/*
		* Count of the current CFR capture from FW.
		* This is helpful to identify any drops in FW.
		*/
		A_UINT32 counter;
		/* Per chain RSSI of the peer, for up to WMI_MAX_CHAINS.
		* Each chain's entry reports the RSSI for different bands in dBm units.
		* Use WMI_UNIFIED_CHAIN_RSSI_GET to extract the value for a particular
		* band.
		* A band value of 0x80 (-128) is invalid.
		*/
		A_UINT32 chain_rssi[WMI_MAX_CHAINS];
		} wmi_peer_cfr_capture_event_fixed_param;

		#define WMI_PEER_CFR_CAPTURE_EVT_STATUS_OK 0x80000000
		#define WMI_PEER_CFR_CAPTURE_EVT_STATUS_OK_S 31

		#define WMI_PEER_CFR_CAPTURE_EVT_STATUS_TX 0x00000003
		#define WMI_PEER_CFR_CAPTURE_EVT_STATUS_TX_S 0



		/* ADD NEW DEFS HERE */

fw/wmi_version.h

+1 −1

Original line number	Diff line number	Diff line
		@@ -36,7 +36,7 @@
		#define __WMI_VER_MINOR_ 0
		/** WMI revision number has to be incremented when there is a
		* change that may or may not break compatibility. */
		#define __WMI_REVISION_ 632
		#define __WMI_REVISION_ 633

		/** The Version Namespace should not be normally changed. Only
		* host and firmware of the same WMI namespace will work