power: smb1351-charger: Add SMB1351 software JEITA support

				power source detection (APSD). If this is set

				charger detection is done by DCIN UV irq.

- qcom,charging-disabled	This is a bool property which disables charging.

- qcom,using-pmic-therm		This property indicates thermal pin connected to pmic or smb.

- qcom,bms-psy-name		This is a string and it points to the bms

				power supply name.

- qcom,iterm-ma			Specifies the termination current to indicate end-of-charge.

				property should be used with 'qcom,iterm-disabled'

				to ensure EOC detection in charger is disabled.

- qcom,parallel-charger		Boolean value which enables the parallel charger.

- qcom,chg-vadc			Corresponding VADC device's phandle.

- qcom,chg-adc_tm		phandle to the corresponding VADC device to read the ADC channels.

- qcom,batt-cold-decidegc	Cold battery temperature in decidegC.

- qcom,batt-hot-decidegc	Hot battery temperature in decidegC.

- qcom,batt-missing-decidegc	This is a property indicating battery missing temperature, if

				higher than it, battery should exist.

- qcom,batt-warm-decidegc:	Warm battery temperature in decidegC. After hitting this threshold,

				"qcom,warm-bat-ma" defines maximum charging current and

				"qcom,warm-bat-mv" defines maximum target voltage.

- qcom,batt-cool-decidegc:       Cool battery temperature in decidegC. After hitting this threshold,

				"qcom,cool-bat-ma" defines maximum charging current and

				"qcom,cool-bat-mv" defines maximum target voltage.

- qcom,batt-warm-ma:		Maximum warm battery charge current in milli-amps.

- qcom,batt-cool-ma:		Maximum cool battery charge current in milli-amps.

- qcom,batt-warm-mv:		Maximum warm battery target voltage in milli-volts.

- qcom,batt-cool-mv:		Maximum cool battery target voltage in milli-volts.

Example for standalone charger:

&i2c_4 {

	smb1351_otg_supply: smb1351-charger@1d {

	smb1351_otg_supply: smb1351-charger@57 {

		compatible = "qcom,smb1351-charger";

		reg = <0x1d>;

		reg = <0x57>;

		interrupt-parent = <&msm_gpio>;

		interrupts = <62 2>;

		pinctrl-names = "default";

		qcom,recharge-mv = <100>;

		qcom,bms-psy-name = "bms";

		regulator-name = "smb1351_otg_vreg";

		qcom,using-pmic-therm;

		qcom,chg-adc_tm = <&pm8916_adc_tm>;

		qcom,chg-vadc = <&pm8916_vadc>;

		qcom,batt-hot-decidegc = <550>;

		qcom,batt-cold-decidegc = <0>;

		qcom,batt-missing-decidegc = <(-200)>;

		qcom,batt-warm-decidegc = <500>;

		qcom,batt-cool-decidegc = <50>;

		qcom,batt-warm-ma = <350>;

		qcom,batt-cool-ma = <350>;

		qcom,batt-warm-mv = <4200>;

		qcom,batt-cool-mv = <4200>;

	};

};