Merge "power: smb135x-charger: Add a DT node to disable BMD algorithm"

				below the float voltage that is required in

				order to initiate a new charging cycle.

				Supported values are: 50, 100, 200 and 300mV.

- qcom,bmd-algo-disabled	Indicates if the battery missing detection algorithm

				is disabled. If this node is present SMB uses

				the THERM pin for battery missing detection.

- regulator-name		A string used as a descriptive name for OTG regulator.

Example:

#define CHG_STAT_ACTIVE_HIGH_BIT	BIT(1)

#define CHG_STAT_IRQ_ONLY_BIT		BIT(4)

#define CHG_19_REG			0x19

#define BATT_MISSING_ALGO_BIT		BIT(2)

#define BATT_MISSING_THERM_BIT		BIT(1)

#define VFLOAT_REG			0x1E

/* Irq Config registers */

	bool				usb_present;

	bool				dc_present;

	bool				bmd_algo_disabled;

	int				vfloat_mv;

	int				safety_time;

	int				resume_delta_mv;

		}

	}

	/* battery missing detection */

	rc = smb135x_masked_write(chip, CHG_19_REG,

			BATT_MISSING_ALGO_BIT | BATT_MISSING_THERM_BIT,

			chip->bmd_algo_disabled ? BATT_MISSING_THERM_BIT :

						BATT_MISSING_ALGO_BIT);

	if (rc < 0) {

		dev_err(chip->dev, "Couldn't set batt_missing config = %d\n",

									rc);

		return rc;

	}

	smb135x_charging(chip, chip->chg_enabled);

	/* interrupt enabling - active low */

		return -EINVAL;

	}

	chip->bmd_algo_disabled = of_property_read_bool(node,

						"qcom,bmd-algo-disabled");

	chip->dc_psy_type = -EINVAL;

	dc_psy_type = of_get_property(node, "qcom,dc-psy-type", NULL);

	if (dc_psy_type) {