Merge "ARM: dts: msm: Add device node for YUV sensor"

    - "shinetech,hi256"

    - "shinetech,s5k4e1"

    - "ovti,ov5645"

    - "qcom,mt9m114"

- reg : should contain i2c slave address of the device

- qcom,csiphy-sd-index : should contain csiphy instance that will used to

    receive sensor data

		clock-names = "cam_src_clk", "cam_clk";

	};

	qcom,camera@90 {

		compatible = "qcom,mt9m114";

		reg = <0x90>;

		qcom,slave-id = <0x90 0x0 0x2481>;

		qcom,csiphy-sd-index = <1>;

		qcom,csid-sd-index = <1>;

		qcom,mount-angle = <90>;

		qcom,sensor-name = "mt9m114";

		cam_vdig-supply = <&pm8994_l3>;

		cam_vio-supply = <&pm8994_lvs1>;

		cam_vana-supply = <&pm8994_l17>;

		qcom,cam-vreg-name = "cam_vdig", "cam_vio", "cam_vana";

		qcom,cam-vreg-type = <0 1 0>;

		qcom,cam-vreg-min-voltage = <1200000 0 2700000>;

		qcom,cam-vreg-max-voltage = <1200000 0 2700000>;

		qcom,cam-vreg-op-mode = <105000 0 80000>;

		qcom,gpio-no-mux = <0>;

		pinctrl-names = "cam_default", "cam_suspend";

		pinctrl-0 = <&cam_sensor_mclk1_active &cam_sensor_rear2_active>;

		pinctrl-1 = <&cam_sensor_mclk1_suspend &cam_sensor_rear2_suspend>;

		gpios = <&msm_gpio 14 0>,

			<&msm_gpio 94 0>,

			<&msm_gpio 93 0>;

		qcom,gpio-reset = <1>;

		qcom,gpio-req-tbl-num = <0 1>;

		qcom,gpio-req-tbl-flags = <1 0>;

		qcom,gpio-req-tbl-label = "CAMIF_MCLK1",

					  "CAM_RESET1";

		qcom,gpio-set-tbl-num = <1 1>;

		qcom,gpio-set-tbl-flags = <0 2>;

		qcom,gpio-set-tbl-delay = <1000 30000>;

		qcom,csi-lane-assign = <0x4320>;

		qcom,csi-lane-mask = <0x3>;

		qcom,sensor-position = <1>;

		qcom,sensor-mode = <1>;

		qcom,cci-master = <0>;

		clocks = <&clock_mmss clk_mclk1_clk_src>,

			<&clock_mmss clk_camss_mclk1_clk>;

		clock-names = "cam_src_clk", "cam_clk";

	};

	qcom,camera@2 {

		cell-index = <2>;

		compatible = "qcom,camera";