Loading drivers/net/arm/at91_ether.c +19 −13 Original line number Diff line number Diff line Loading @@ -577,7 +577,7 @@ static void at91ether_sethashtable(struct net_device *dev) /* * Enable/Disable promiscuous and multicast modes. */ static void at91ether_set_rx_mode(struct net_device *dev) static void at91ether_set_multicast_list(struct net_device *dev) { unsigned long cfg; Loading Loading @@ -808,7 +808,7 @@ static int at91ether_close(struct net_device *dev) /* * Transmit packet. */ static int at91ether_tx(struct sk_buff *skb, struct net_device *dev) static int at91ether_start_xmit(struct sk_buff *skb, struct net_device *dev) { struct at91_private *lp = netdev_priv(dev); Loading @@ -828,7 +828,7 @@ static int at91ether_tx(struct sk_buff *skb, struct net_device *dev) dev->trans_start = jiffies; } else { printk(KERN_ERR "at91_ether.c: at91ether_tx() called, but device is busy!\n"); printk(KERN_ERR "at91_ether.c: at91ether_start_xmit() called, but device is busy!\n"); return 1; /* if we return anything but zero, dev.c:1055 calls kfree_skb(skb) on this skb, he also reports -ENETDOWN and printk's, so either we free and return(0) or don't free and return 1 */ Loading Loading @@ -965,6 +965,21 @@ static void at91ether_poll_controller(struct net_device *dev) } #endif static const struct net_device_ops at91ether_netdev_ops = { .ndo_open = at91ether_open, .ndo_stop = at91ether_close, .ndo_start_xmit = at91ether_start_xmit, .ndo_get_stats = at91ether_stats, .ndo_set_multicast_list = at91ether_set_multicast_list, .ndo_set_mac_address = set_mac_address, .ndo_do_ioctl = at91ether_ioctl, .ndo_validate_addr = eth_validate_addr, .ndo_change_mtu = eth_change_mtu, #ifdef CONFIG_NET_POLL_CONTROLLER .ndo_poll_controller = at91ether_poll_controller, #endif }; /* * Initialize the ethernet interface */ Loading Loading @@ -1005,17 +1020,8 @@ static int __init at91ether_setup(unsigned long phy_type, unsigned short phy_add spin_lock_init(&lp->lock); ether_setup(dev); dev->open = at91ether_open; dev->stop = at91ether_close; dev->hard_start_xmit = at91ether_tx; dev->get_stats = at91ether_stats; dev->set_multicast_list = at91ether_set_rx_mode; dev->set_mac_address = set_mac_address; dev->netdev_ops = &at91ether_netdev_ops; dev->ethtool_ops = &at91ether_ethtool_ops; dev->do_ioctl = at91ether_ioctl; #ifdef CONFIG_NET_POLL_CONTROLLER dev->poll_controller = at91ether_poll_controller; #endif SET_NETDEV_DEV(dev, &pdev->dev); Loading Loading
drivers/net/arm/at91_ether.c +19 −13 Original line number Diff line number Diff line Loading @@ -577,7 +577,7 @@ static void at91ether_sethashtable(struct net_device *dev) /* * Enable/Disable promiscuous and multicast modes. */ static void at91ether_set_rx_mode(struct net_device *dev) static void at91ether_set_multicast_list(struct net_device *dev) { unsigned long cfg; Loading Loading @@ -808,7 +808,7 @@ static int at91ether_close(struct net_device *dev) /* * Transmit packet. */ static int at91ether_tx(struct sk_buff *skb, struct net_device *dev) static int at91ether_start_xmit(struct sk_buff *skb, struct net_device *dev) { struct at91_private *lp = netdev_priv(dev); Loading @@ -828,7 +828,7 @@ static int at91ether_tx(struct sk_buff *skb, struct net_device *dev) dev->trans_start = jiffies; } else { printk(KERN_ERR "at91_ether.c: at91ether_tx() called, but device is busy!\n"); printk(KERN_ERR "at91_ether.c: at91ether_start_xmit() called, but device is busy!\n"); return 1; /* if we return anything but zero, dev.c:1055 calls kfree_skb(skb) on this skb, he also reports -ENETDOWN and printk's, so either we free and return(0) or don't free and return 1 */ Loading Loading @@ -965,6 +965,21 @@ static void at91ether_poll_controller(struct net_device *dev) } #endif static const struct net_device_ops at91ether_netdev_ops = { .ndo_open = at91ether_open, .ndo_stop = at91ether_close, .ndo_start_xmit = at91ether_start_xmit, .ndo_get_stats = at91ether_stats, .ndo_set_multicast_list = at91ether_set_multicast_list, .ndo_set_mac_address = set_mac_address, .ndo_do_ioctl = at91ether_ioctl, .ndo_validate_addr = eth_validate_addr, .ndo_change_mtu = eth_change_mtu, #ifdef CONFIG_NET_POLL_CONTROLLER .ndo_poll_controller = at91ether_poll_controller, #endif }; /* * Initialize the ethernet interface */ Loading Loading @@ -1005,17 +1020,8 @@ static int __init at91ether_setup(unsigned long phy_type, unsigned short phy_add spin_lock_init(&lp->lock); ether_setup(dev); dev->open = at91ether_open; dev->stop = at91ether_close; dev->hard_start_xmit = at91ether_tx; dev->get_stats = at91ether_stats; dev->set_multicast_list = at91ether_set_rx_mode; dev->set_mac_address = set_mac_address; dev->netdev_ops = &at91ether_netdev_ops; dev->ethtool_ops = &at91ether_ethtool_ops; dev->do_ioctl = at91ether_ioctl; #ifdef CONFIG_NET_POLL_CONTROLLER dev->poll_controller = at91ether_poll_controller; #endif SET_NETDEV_DEV(dev, &pdev->dev); Loading