Merge "dt-bindings: regulator: Add optional RPM-SMD regulator properties"

			  "pmic4-ldo" for PMIC4.

			  "pmic5-ldo" for PMIC5.

- qcom,supported-modes

	Usage:      optional; BOB regulators only

	Value type: <prop-encoded-array>

	Definition: A list of integers specifying the PMIC regulator modes

		    supported by this regulator.  Supported values are

		    RPMH_REGULATOR_MODE_* (i.e. 0 to 4).  Elements must be

		    specified in order from lowest to highest.

- qcom,mode-threshold-currents

	Usage:      required if qcom,supported-modes is specified

	Value type: <prop-encoded-array>

	Definition: A list of integers specifying minimum allowed current in

		    microamps for each of the modes listed in

		    qcom,supported-modes.  The first element should always be 0.

		    Elements must be specified in order from lowest to highest.

[Second Level Nodes]

Required properties:

				regulator to be enabled.  Each element supports

				the same set of values as the

				qcom,init-pin-ctrl-enable property listed below.

- qcom,min-dropout-voltage:    Specifies the minimum voltage level difference that the

				parent supply regulator must output above the output of

				this regulator.  It is only meaningful if the property

				<regulator-name>-parent-supply has been specified in

				the first level node.

The following properties specify initial values for parameters to be sent to the

RPM in regulator requests.