Merge "disp: msm: dsi: enable DMA cmd scheduling for video mode panels"

		dsi_hw_ops.reset_trig_ctrl(&dsi_ctrl->hw,

				&dsi_ctrl->host_config.common_config);

	/* check if custom dma scheduling line needed */

	if (flags & DSI_CTRL_CMD_CUSTOM_DMA_SCHED)

	/*

	 * Always enable DMA scheduling for video mode panel.

	 *

	 * In video mode panel, if the DMA is triggered very close to

	 * the beginning of the active window and the DMA transfer

	 * happens in the last line of VBP, then the HW state will

	 * stay in ‘wait’ and return to ‘idle’ in the first line of VFP.

	 * But somewhere in the middle of the active window, if SW

	 * disables DSI command mode engine while the HW is still

	 * waiting and re-enable after timing engine is OFF. So the

	 * HW never ‘sees’ another vblank line and hence it gets

	 * stuck in the ‘wait’ state.

	 */

	if ((flags & DSI_CTRL_CMD_CUSTOM_DMA_SCHED) ||

		(dsi_ctrl->host_config.panel_mode == DSI_OP_VIDEO_MODE))

		dsi_configure_command_scheduling(dsi_ctrl, cmd_mem);

	dsi_ctrl->cmd_mode = (dsi_ctrl->host_config.panel_mode ==