Commit 649c6059 authored May 26, 2016 by Ziyuan Xu Committed by Ulf Hansson Jul 25, 2016

mmc: mmc: Fix HS switch failure in mmc_select_hs400()



To slove the issue which was found on gru board for hs400.

[    4.616946] sdhci: Secure Digital Host Controller Interface driver
[    4.623135] sdhci: Copyright(c) Pierre Ossman
[    4.722575] sdhci-pltfm: SDHCI platform and OF driver helper
[    4.730962] sdhci-arasan fe330000.sdhci: No vmmc regulator found
[    4.737444] sdhci-arasan fe330000.sdhci: No vqmmc regulator found
[    4.774930] mmc0: SDHCI controller on fe330000.sdhci [fe330000.sdhci] using ADMA
[    4.980295] mmc0: switch to high-speed from hs200 failed, err:-84
[    4.986487] mmc0: error -84 whilst initialising MMC card

We should change HS400 mode selection timing to meet JEDEC
specification. The JEDEC 5.1 said that change the frequency to <= 52MHZ
after HS_TIMING switch. Refer to section 6.6.2.3 "HS400" timing mode
selection:
Set the "Timing Interface" parameter in the HS_TIMING[185] field of the
Extended CSD register to 0x1 to switch to High Speed mode and then set
the clock frequency to a value not greater than 52MHZ.

Signed-off-by: Ziyuan Xu <xzy.xu@rock-chips.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

parent 987aa5f8

drivers/mmc/core/mmc.c

+4 −4

Original line number	Diff line number	Diff line
		@@ -1082,10 +1082,6 @@ static int mmc_select_hs400(struct mmc_card *card)
		host->ios.bus_width == MMC_BUS_WIDTH_8))
		return 0;

		/* Reduce frequency to HS frequency */
		max_dtr = card->ext_csd.hs_max_dtr;
		mmc_set_clock(host, max_dtr);

		/* Switch card to HS mode */
		val = EXT_CSD_TIMING_HS;
		err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
		@@ -1101,6 +1097,10 @@ static int mmc_select_hs400(struct mmc_card *card)
		/* Set host controller to HS timing */
		mmc_set_timing(card->host, MMC_TIMING_MMC_HS);

		/* Reduce frequency to HS frequency */
		max_dtr = card->ext_csd.hs_max_dtr;
		mmc_set_clock(host, max_dtr);

		err = mmc_switch_status(card);
		if (err)
		goto out_err;