Donate to e Foundation | Murena handsets with /e/OS | Own a part of Murena! Learn more

Commit 17553c88 authored by H Hartley Sweeten's avatar H Hartley Sweeten Committed by Greg Kroah-Hartman
Browse files

staging: comedi: s626: remove 'IsBoardRevA' comment 



IsBoardRevA is not defined in the driver. Remove the comment
about it.

Signed-off-by: default avatarH Hartley Sweeten <hsweeten@visionengravers.com>
Cc: Ian Abbott <abbotti@mev.co.uk>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 59747847

drivers/staging/comedi/drivers/s626.c

+2 −23
Original line number Diff line number Diff line
@@ -2488,29 +2488,8 @@ static void s626_initialize(struct comedi_device *dev) 
	/*  Init GPIO so that ADC Start* is negated. */

	WR7146(P_GPIO, GPIO_BASE | GPIO1_HI);



	/* IsBoardRevA is a boolean that indicates whether the board is RevA.

	 *

	 * VERSION 2.01 CHANGE: REV A & B BOARDS NOW SUPPORTED BY DYNAMIC

	 * EEPROM ADDRESS SELECTION.  Initialize the I2C interface, which

	 * is used to access the onboard serial EEPROM.  The EEPROM's I2C

	 * DeviceAddress is hardwired to a value that is dependent on the

	 * 626 board revision.  On all board revisions, the EEPROM stores

	 * TrimDAC calibration constants for analog I/O.  On RevB and

	 * higher boards, the DeviceAddress is hardwired to 0 to enable

	 * the EEPROM to also store the PCI SubVendorID and SubDeviceID;

	 * this is the address at which the SAA7146 expects a

	 * configuration EEPROM to reside.  On RevA boards, the EEPROM

	 * device address, which is hardwired to 4, prevents the SAA7146

	 * from retrieving PCI sub-IDs, so the SAA7146 uses its built-in

	 * default values, instead.

	 */



	/*     devpriv->I2Cards= IsBoardRevA ? 0xA8 : 0xA0; // Set I2C EEPROM */

	/*  DeviceType (0xA0) */

	/*  and DeviceAddress<<1. */



	devpriv->I2CAdrs = 0xA0;	/*  I2C device address for onboard */

	/*  eeprom(revb) */

	/* I2C device address for onboard eeprom (revb) */

	devpriv->I2CAdrs = 0xA0;



	/*  Issue an I2C ABORT command to halt any I2C operation in */

	/* progress and reset BUSY flag. */