Merge "ARM: dts: msm: Add display panel support for SDM670 QRD" (d2e92779) · Commits · e / devices / android_kernel_fairphone_FP3

arch/arm64/boot/dts/qcom/dsi-panel-nt36850-truly-dualmipi-wqhd-cmd.dtsi

0 → 100644

+92 −0

Original line number	Diff line number	Diff line
		/* Copyright (c) 2017, The Linux Foundation. All rights reserved.
		*
		* This program is free software; you can redistribute it and/or modify
		* it under the terms of the GNU General Public License version 2 and
		* only version 2 as published by the Free Software Foundation.
		*
		* This program is distributed in the hope that it will be useful,
		* but WITHOUT ANY WARRANTY; without even the implied warranty of
		* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
		* GNU General Public License for more details.
		*/

		&mdss_mdp {
		dsi_dual_nt36850_truly_cmd: qcom,mdss_dsi_nt36850_truly_wqhd_cmd {
		qcom,mdss-dsi-panel-name =
		"Dual nt36850 cmd mode dsi truly panel without DSC";
		qcom,mdss-dsi-panel-type = "dsi_cmd_mode";
		qcom,mdss-dsi-virtual-channel-id = <0>;
		qcom,mdss-dsi-stream = <0>;
		qcom,mdss-dsi-bpp = <24>;
		qcom,mdss-dsi-color-order = "rgb_swap_rgb";
		qcom,mdss-dsi-underflow-color = <0xff>;
		qcom,mdss-dsi-border-color = <0>;

		qcom,mdss-dsi-traffic-mode = "non_burst_sync_event";
		qcom,mdss-dsi-lane-map = "lane_map_0123";
		qcom,mdss-dsi-bllp-eof-power-mode;
		qcom,mdss-dsi-bllp-power-mode;
		qcom,mdss-dsi-tx-eot-append;
		qcom,cmd-sync-wait-broadcast;
		qcom,mdss-dsi-lane-0-state;
		qcom,mdss-dsi-lane-1-state;
		qcom,mdss-dsi-lane-2-state;
		qcom,mdss-dsi-lane-3-state;
		qcom,mdss-dsi-wr-mem-start = <0x2c>;
		qcom,mdss-dsi-wr-mem-continue = <0x3c>;
		qcom,mdss-dsi-te-pin-select = <1>;
		qcom,mdss-dsi-te-dcs-command = <1>;
		qcom,mdss-dsi-te-check-enable;
		qcom,mdss-dsi-te-using-te-pin;
		qcom,mdss-dsi-panel-timings =
		[da 34 24 00 64 68 28 38 2a 03 04 00];
		qcom,mdss-dsi-t-clk-pre = <0x29>;
		qcom,mdss-dsi-t-clk-post = <0x03>;
		qcom,mdss-dsi-dma-trigger = "trigger_sw";
		qcom,mdss-dsi-mdp-trigger = "none";
		qcom,mdss-dsi-lp11-init;
		qcom,mdss-dsi-bl-pmic-control-type = "bl_ctrl_wled";
		qcom,mdss-dsi-bl-min-level = <1>;
		qcom,mdss-dsi-bl-max-level = <4095>;
		qcom,mdss-dsi-reset-sequence = <1 10>, <0 10>, <1 10>;
		qcom,mdss-dsi-display-timings {
		timing@0 {
		qcom,mdss-dsi-panel-framerate = <60>;
		qcom,mdss-dsi-panel-width = <720>;
		qcom,mdss-dsi-panel-height = <2560>;
		qcom,mdss-dsi-h-front-porch = <120>;
		qcom,mdss-dsi-h-back-porch = <140>;
		qcom,mdss-dsi-h-pulse-width = <20>;
		qcom,mdss-dsi-h-sync-skew = <0>;
		qcom,mdss-dsi-v-back-porch = <20>;
		qcom,mdss-dsi-v-front-porch = <8>;
		qcom,mdss-dsi-v-pulse-width = <4>;
		qcom,mdss-dsi-h-left-border = <0>;
		qcom,mdss-dsi-h-right-border = <0>;
		qcom,mdss-dsi-v-top-border = <0>;
		qcom,mdss-dsi-v-bottom-border = <0>;
		qcom,mdss-dsi-on-command = [
		15 01 00 00 00 00 02 ff 10
		15 01 00 00 00 00 02 fb 01
		15 01 00 00 00 00 02 36 00
		15 01 00 00 00 00 02 35 00
		39 01 00 00 00 00 03 44 03 e8
		15 01 00 00 00 00 02 51 ff
		15 01 00 00 00 00 02 53 2c
		15 01 00 00 00 00 02 55 01
		05 01 00 00 0a 00 02 20 00
		15 01 00 00 00 00 02 bb 10
		05 01 00 00 78 00 02 11 00
		05 01 00 00 14 00 02 29 00
		];
		qcom,mdss-dsi-off-command = [
		05 01 00 00 14 00 02
		28 00 05 01 00 00 78 00 02 10 00
		];
		qcom,mdss-dsi-on-command-state = "dsi_lp_mode";
		qcom,mdss-dsi-off-command-state = "dsi_hs_mode";
		qcom,mdss-dsi-h-sync-pulse = <0>;
		};
		};
		};
		};

arch/arm64/boot/dts/qcom/sdm670-qrd.dtsi

+25 −0

Original line number	Diff line number	Diff line
		@@ -15,6 +15,7 @@
		#include "sdm670-pmic-overlay.dtsi"
		#include "sdm670-audio-overlay.dtsi"
		#include "smb1355.dtsi"
		#include "sdm670-sde-display.dtsi"

		&qupv3_se9_2uart {
		status = "disabled";
		@@ -255,3 +256,27 @@
		qcom,afe-power-off-delay-us = <6>;
		};
		};

		&dsi_dual_nt36850_truly_cmd {
		qcom,panel-supply-entries = <&dsi_panel_pwr_supply>;
		qcom,mdss-dsi-bl-pmic-control-type = "bl_ctrl_wled";
		qcom,mdss-dsi-bl-min-level = <1>;
		qcom,mdss-dsi-bl-max-level = <4095>;
		qcom,panel-mode-gpio = <&tlmm 76 0>;
		qcom,mdss-dsi-mode-sel-gpio-state = "dual_port";
		qcom,platform-reset-gpio = <&tlmm 75 0>;
		qcom,platform-te-gpio = <&tlmm 10 0>;
		};

		&dsi_dual_nt36850_truly_cmd_display {
		qcom,dsi-display-active;
		};

		&pm660l_wled {
		status = "okay";
		qcom,led-strings-list = [01 02];
		};

		&mdss_mdp {
		#cooling-cells = <2>;
		};

arch/arm64/boot/dts/qcom/sdm670-sde-display.dtsi

+38 −0

Original line number	Diff line number	Diff line
		@@ -25,6 +25,7 @@
		#include "dsi-panel-nt35695b-truly-fhd-video.dtsi"
		#include "dsi-panel-nt35695b-truly-fhd-cmd.dtsi"
		#include "dsi-panel-rm67195-amoled-fhd-cmd.dtsi"
		#include "dsi-panel-nt36850-truly-dualmipi-wqhd-cmd.dtsi"
		#include <dt-bindings/clock/mdss-10nm-pll-clk.h>

		&soc {
		@@ -469,6 +470,29 @@
		ibb-supply = <&lcdb_ncp_vreg>;
		};

		dsi_dual_nt36850_truly_cmd_display: qcom,dsi-display@15 {
		compatible = "qcom,dsi-display";
		label = "dsi_dual_nt36850_truly_cmd_display";
		qcom,display-type = "primary";

		qcom,dsi-ctrl = <&mdss_dsi0 &mdss_dsi1>;
		qcom,dsi-phy = <&mdss_dsi_phy0 &mdss_dsi_phy1>;
		clocks = <&mdss_dsi0_pll BYTECLK_MUX_0_CLK>,
		<&mdss_dsi0_pll PCLK_MUX_0_CLK>;
		clock-names = "src_byte_clk", "src_pixel_clk";

		pinctrl-names = "panel_active", "panel_suspend";
		pinctrl-0 = <&sde_dsi_active &sde_te_active>;
		pinctrl-1 = <&sde_dsi_suspend &sde_te_suspend>;
		qcom,platform-te-gpio = <&tlmm 10 0>;
		qcom,platform-reset-gpio = <&tlmm 75 0>;

		qcom,dsi-panel = <&dsi_dual_nt36850_truly_cmd>;
		vddio-supply = <&pm660_l11>;
		lab-supply = <&lcdb_ldo_vreg>;
		ibb-supply = <&lcdb_ncp_vreg>;
		};

		sde_wb: qcom,wb-display@0 {
		compatible = "qcom,wb-display";
		cell-index = <0>;
		@@ -732,3 +756,17 @@
		};
		};
		};

		&dsi_dual_nt36850_truly_cmd {
		qcom,mdss-dsi-t-clk-post = <0x0E>;
		qcom,mdss-dsi-t-clk-pre = <0x30>;
		qcom,mdss-dsi-display-timings {
		timing@0{
		qcom,mdss-dsi-panel-phy-timings = [00 1f 08 08 24 23 08
		08 05 03 04 00];
		qcom,display-topology = <2 0 2>,
		<1 0 2>;
		qcom,default-topology-index = <0>;
		};
		};
		};