ARM: dts: msm: Add new Camera Node

/*

 * Copyright (c) 2016-2018, The Linux Foundation. All rights reserved.

 * Copyright (c) 2016-2020, The Linux Foundation. All rights reserved.

 *

 * This program is free software; you can redistribute it and/or modify

 * it under the terms of the GNU General Public License version 2 and

		clock-cntl-level = "turbo";

		clock-rates = <24000000>;

	};

	qcom,cam-sensor@3 {

		cell-index = <0>;

		compatible = "qcom,cam-sensor";

		reg = <0x0>;

		csiphy-sd-index = <0>;

		sensor-position-roll = <270>;

		sensor-position-pitch = <0>;

		sensor-position-yaw = <180>;

		led-flash-src = <&led_flash_rear>;

		actuator-src = <&actuator_rear>;

		ois-src = <&ois_rear>;

		eeprom-src = <&eeprom_rear>;

		cam_vio-supply = <&camera_vio_ldo>;

		cam_vana-supply = <&camera_vana_ldo>;

		cam_vdig-supply = <&camera_ldo>;

		cam_clk-supply = <&titan_top_gdsc>;

		regulator-names = "cam_vio", "cam_vana", "cam_vdig",

			"cam_clk";

		rgltr-cntrl-support;

		rgltr-min-voltage = <1800000 2850000 1352000 0>;

		rgltr-max-voltage = <1800000 2850000 1352000 0>;

		rgltr-load-current = <0 80000 105000 0>;

		gpio-no-mux = <0>;

		pinctrl-names = "cam_default", "cam_suspend";

		pinctrl-0 = <&cam_sensor_mclk0_active

				&cam_sensor_rear_active>;

		pinctrl-1 = <&cam_sensor_mclk0_suspend

				&cam_sensor_rear_suspend>;

		gpios = <&tlmm 13 0>,

			<&tlmm 30 0>;

		gpio-reset = <1>;

		gpio-req-tbl-num = <0 1>;

		gpio-req-tbl-flags = <1 0>;

		gpio-req-tbl-label = "CAMIF_MCLK0",

					"CAM_RESET0";

		sensor-mode = <0>;

		cci-master = <0>;

		status = "ok";

		clocks = <&clock_camcc CAM_CC_MCLK0_CLK>;

		clock-names = "cam_clk";

		clock-cntl-level = "turbo";

		clock-rates = <24000000>;

	};

};